Saturday, April 19, 2008

Alternating Current – Minimum Approach Distance

The following table is from Occupational Safety & Health Standards Board of the California Cal/OSHA program website. Please see this website for more information.

It is related to conductors and equipment energized over 7,500 volts

Alternating Current – Minimum Approach Distance

Normal Voltage Range (Phase to Phase)Kilovolt Approach Distance Phase to Ground Exposure
Above 0.6 to 152 ft 1 in.
Above 15 to 362 ft. 4 in.
Above 36 to 462 ft 7 in.
Above 46 to 72.53 ft 0 in.
Above 72.5 to 1213 ft 4 in.
Above 121 to 1453 ft 7 in.
Above 145 to 1694 ft 0 in.
Above 169 to 2425 ft. 3 in.
Above 242 to 3628 ft 6 in.
Above 362 to 55211 ft. 3in.
Above 552 to 76515 ft 0 in.

Labels: , ,

Wednesday, April 9, 2008

Human Body Resistance and Capacitance

Here is an interesting piece written by Paul E. Schoen of P S Technology, Inc.

There is some more information [regarding the resistance of a human body] at , where it states that the external human body resistance is about 1k to 100k Ohms, and the internal resistance is 300 to 1000 ohms. Only a thin layer of dry skin separates the internal resistance from an external object.

The human body capacitance to a far ground is 100-200 pF, which is really a minimum value. This correlates to an impedance of about 13 megohms at 60 Hz, which corresponds to a minimum of 9 uA at 120 VAC to ground. This is enough to be sensed and used for capacitively operated light dimmers.

Here is a way to measure your body capacitance:

The inside of your body can be considered a conductor, and thus if you place your hand flat on a metal plate, you will form a capacitor with an area of perhaps 15 square inches, with a thin (maybe 0.005”) insulating layer of dry skin, which will form a capacitor much higher in value than the 200 pF stated above. According to a formula in , this would be C = 0.2249 * k * A / d = 1350 pF, (assuming k for skin is 2, about like dry paper). This will be an impedance of about 2 megohms , and current of 60 uA. This is still below the normal threshold of sensation, and still far below the usual safe current levels of 1 to 5 mA.

The actual thickness of the epidermis (per ) varies from 0.05 mm (0.002”) for eyelids to 1.5 mm (0.06”) for palms and soles, but the actual outer layer of the epidermis that is a good insulator is composed of flat, dead cells, which is much thinner. So the capacitance could be much higher than the quick estimate above.

Probably the main reason for electrical current to reach levels high enough for electrocution to occur (6 to 200 mA for 3 seconds, according to ), is when skin becomes sweaty or otherwise loses its dry protective layer, which quickly exposes the underlying 1000 ohms or less, which will conduct 120 mA at 120 VAC.

There are safe ways to measure the body’s resistance and capacitance using realistic higher voltages, skin conditions, and contact surfaces, but I’m not going to suggest anyone try it. Suffice it to say that ohmmeter readings are misleading, and any carelessness around any kind of voltage source can be dangerous.

For very high voltages, there are standard minimum distances that must be maintained between a worker and an energized line: . I found this on a search for rubber glove testing.

The field intensity near high voltage lines is so great that it might be fatal to touch them even if you were suspended in free air. You may notice that birds can sit on lower voltage transmission lines which are 5kV to 50 kV or so, but not on 200kV+ lines.

Labels: , , ,

Tuesday, July 10, 2007

High Voltage Safety

There are many safety procedures and safety equipment that must be followed to maximize high voltage safety. Sometimes it is easy to forget one of the most obvious aspects of high voltage--you cannot see it. Thus, it is easy to be complacent while working around high voltage and forget that it is there. Even in the presence of a "Danger High Voltage" sign or while wearing protective clothing, the danger is not always apparent.

Labels: ,